Do you know what details can not be ignored when installing EPS lines? How much convenience can we pay attention to these details? next Hainan EPS The editor gives you a detailed introduction:

First of all, the installation of EPS is based on the device construction drawings, and the positioning line points are snapped at the position of EPS line components to be installed. Cut the EPS line according to the device dimension in the drawing. EPS components are of standard dimensions, and the width of splicing joint shall be considered when cutting. When posting EPS components, the grid cloth shall be turned over. In case of special circumstances, it can be directly posted without turning over.

Secondly, the bonding agent for polyphenyl EPS components shall be high-quality bonding mortar, which shall be pasted by thin layer full bonding method. The EPS components shall be kneaded vigorously to make the mortar overflow from the periphery. The width of the bonding joint shall not be more than 3mm. The bonding joint shall follow the bonding, and the mortar joint shall be plump, and the appearance of the EPS components shall be neat.

    Hainan Sculpture The manufacturer's warm tip: for larger EPS components, supports are required for temporary fixation during installation. If splicing is required for the device, the assembly dimension and viewpoint shall be measured in advance, and the pre assembly shall be carried out in a flat place. The gap shall not be greater than 3mm. High quality bonding mortar shall be used as the splicing and bonding data. The mortar consistency can be slightly higher, and the thin layer full bonding method shall be used. Slightly and evenly knead and hammer the joints to meet the requirements.

After splicing, the mortar joint shall be leveled with a mortar knife to make the EPS components integrated. After drying, if there is residual bonding mortar left at the seam of EPS component, sand paper can be used for polishing. After drying, the splicing part of EPS components shall be treated with special anti cracking adhesive for EPS components. See the instructions for use of special anti crack adhesive for treatment. Self developed, self produced and self sold, Huigu Packaging is a manufacturer of EPS line components.

Want to know more about Hainan EPS component For detailed information about the manufacturer, please continue to pay attention to the official website of Hainan Jin'ao City Garden Co., Ltd!