Hainan EPS The effect of waterproof and water resistance is introduced by Jin'ao Art Editor. Waterproof and water resistant effects of Hainan EPS:

EPS components have high strength, excellent water resistance and good toughness. Simple construction is an important advantage of this product. During construction, no embedded parts or riveting parts are required. The special bonding mortar provided by our company can be directly bonded to the wall base. This kind of mortar has high bonding strength, and slightly larger components will not fall off even when people walk on it after being pasted on the wall base.

EPS components are easy to install. Using special bonding materials and methods, one person can install and construct, especially for large components, only bonding installation is required. The decorative line (component) is smooth and beautiful, and there is no gap between the lines. Because the gap repair material is used between the two lines, the gap disappears completely. There will be no cracks in future use. Completely solved the problem of external thermal insulation of cold and hot bridges, allowing designers and builders to give full play.

EPS production process:

1. First, paint release agent on the inner surface of the mold, that is, the surface in direct contact with the cement.

2. Use cement mixed with water and a little yellow sand to brush the inner surface of the mold once, so that the pores on the surface can be largely controlled by brushing once first.

3. Yellow sand and cement shall be mixed evenly at a ratio of 1:1.5, and then mixed with water. We should also use the same amount when using it. It can be mixed into ordinary concrete, and less water will cause pores on the surface.

4. Add more water and cement, and the concave will slip. The rest of this step is "feeding". First, use a bricklayer's tool to plaster a layer of mixed mortar on the surface of the mold, with an average of 4-5mm.

We also need to reasonably plant the reinforcement of EPS components. There should be a reinforcement at a distance of about 20cm. After determining the position of the embedded parts, we should also leave a butt welded framework on the product, and then plaster the remaining mortar. The thickness should be more than 1cm and the thickness of the product should be uniform. More about Hainan Sculpture 、 Hainan GRC component 、 Hainan EPS component Please pay attention to the official website of Hainan Jin'ao Garden Sculpture Art Co., Ltd.