Hainan EPS component In the process of mortar allocation, an important task before the construction of EPS components is to allocate mortar. This step is very important. The quality of mortar directly affects the firmness of parts pasting. Now let's talk about the process of mortar allocation for EPS components.

1. The mortar used in construction is a special bonded composite mortar specially configured for the requirements of EPS component base surface. EPS component 2. During construction, electric mixer shall be used for mixing. The mixing shall be sufficient, uniform and of moderate consistency. When mixing, add water first, then add mortar. The mixing bucket rotates counterclockwise 20-30 times, and the mixing impeller rotates clockwise 700 times. The mortar height (mixing raw materials) is always higher than the mixing impeller. Even if the mixing impeller rotates at a high speed, it is better not to see the blade.

3. After the EPS component mortar is mixed, stop the rotation of the mixing bucket and the mixing impeller. The other motor controls the mixing bucket to turn over and pour out the mortar. It needs to stand for five minutes before use, and then mix again before use. The mixed mortar should be used up within three hours, so as not to miss the good time of mortar use and affect the effect.

The above is a detailed introduction to the process of configuring mortar for EPS component construction. In addition, special attention should be paid to the fact that the mixer should not salvage mortar because of the mixing effect, and attention should be paid to prevent the dangerous situation of arm twisting into the machine.